It is helpful to test a New Ethernet Cable once you install it by the Testing Tools. There may be certain type of Errors like the cables to be damaged or there might be a fixing problem. Further electrical to the Interruption and the Environmental Elements can also effect. It is very obvious procedure to present the statistic report after the installment of the Network that each and every wire is fit and working efficiently so that there must not be any queries like customer going down and reporting against the system of cables you installed.
The testing of the cables usually depends upon the type of the usage of the Ethernet cables like the telephone cable will require less testing while the others like Cat5e or Cat 6 Ethernet cables will require detailed testing.
Small tester consists of the wire mapping tool which is used to check that either the pair of wires are connected properly or not. These are cheap and less time consuming. It also checks that either a Ethernet cable is patched into a switch port or not. Similar there are more expensive ones which are more precise than the cheap ones. During installing network cables, there is all the time degradation of signals as it is being transmit along the cable lines. This condition is known as shrinking or in scientific term attenuation. There are some other tools apart from the tester tool as well, but the cable tester is the most significant. It is always good to test the cables because it gives a better result as a buyer and a sailor as well. It will take your sales to a next level if you are a sailor.