Splitter and Switches

The DiSEqC switch will enable the user to select one LNB signal between 4 different LNBs of any type.The 4 input ports marked LNB A, B, C or D are connected to the 4 LNBs, which may be on 4 different dishes, and the output marked OUT is connected to the receiver.The selection of the LNBs is done by choosing the appropriate Tone Burst A, B, C, or D in the menu of the receiver. Compatible with all brands of receivers, including Coship, BEC, Satwork, Traxis, Prosat, Pansat, Fortec Star, Topfield, Twinhan, VisionPlus, Goldsat, and much more. Features: Frequency Range : 900-2400MHz Insertion Loss: 3dB Power Passing : 500mA Max IN/OUT :SatA, SatB, SatC, SatD, To Reciever  

70 item(s)
+

Minimum quantity for "Lot of 10 Satellite Switches 4x1 DiSEqC" is 1.

$49.99
Add to wish list

The DirecTV PI-21 21v 1.51 PI-21 Power Inserter is designed for use on the SWiMLine dish. Power Insterter: The SWM switch requires more power than the receivers provide for traditional LNBs orswitches. DirecTV includes a power inserter with each SWM unit. This simply plugs in to astandard electrical outlet IN-DOORS and feeds power to the switch or LNB. It has simply two coaxports, one to the receivers and one to the switch/LNB. The powered-output is colored red and islabeled SWM, to feed the switch/LNB. The other port is labeled IRD to feed receivers. Reversingthe connections will damage the receivers.The power inserter generally would be installed near the point where wires enter the home from the dish.Some users may need to place the power inserter in a different location, due to outlet limiations or the desire touse a UPS battery-backup. The power inserter can be placed after the splitter as long as the splitter is designed topass power to only one port, and the receiver with the power inserter is connected to this port. Features: Frequency Range 2-2150Mhz Can be used for the SWM-8 UL Listed Output 21v/ 1.2A max/ 25.2W max. Input 100~120Vac/ 60Hz/ 0.6A max/ 30W max Insertion loss 1.5db typ.

38 item(s)
+

Minimum quantity for "DirecTV PI 21 21v 1.51 Power Inserter For Swimline Dish" is 1.

$17.99
Add to wish list

Automatically switch between two LNBs allowing reception from multiple satellites with any 22KHz compatible receiver.22KHz tone switches are the most reliable switches on the market. We have load tested this switch with over 3 times the current draw rating and hot patched over 1000 cycles, which blew every other of the competition's switches leaving them dead. 22KHz switches kept reliably switching for thousands of cycles under this tremendous load! Example of a two room connection with a 22KHz switch. Features: 2x1 Multi Switch Frequency Range: 950-2150MHz Insertion Loss: 1.5dB Isolation: dB Power Supply: 12-20V / 25mA Passing Current: 300mA Max Control Signal: 0 / 22KHz / tone buse Diagram:

27 item(s)
+

Minimum quantity for "Lot 10 Satellite Switches 2x1 22KHz DirecTV Switch" is 1.

$24.99
Add to wish list

8-Way 1GHz Splitter 1-Port Power Passing Digital Vertical Cable UHF VHF Commercial Grade JVI HDTV 5-1000MHz Combiner Signal JVI Antenna 75Ohm Distribution Component, Coax RF DC Passive Features: Digital Ready 1GHz (5-1000 MHz) Indoor/Outdoor Use Modified Conical Seizure Mechanisms Zinc Alloy Die-Cast, Tin Plated Housing 120dB EMI / RFI Isolation Contractor grade 8-way vertical splitters for cable TV, high-speed internet and digital telephone networks are ideal for indoor and outdoor installations with one 50VDC 0.3A Max power passing port. Features Antronix cable TV splitters are the finest cable tv cable splitters manufactured Antronix cable TV splitters offer full 1 GHz bandwidth Antronix proprietary cable TV splitters ferrite core material to provide ultra linear performance that is consistent from ferrite to ferrite. Excellent RF performance Antronix cable TV splitters The Antronix cable TV splitter housing and back plate are zinc alloy to eliminate rust and corrosion Fully soldered-back cable TV splitters for optimal RFI Machine threaded "F" port cable TV splitters 1 port In - 8 ports Out Frequency Range: 5-1000MHz Attenuation: -11db Connectors: F coaxial

10 item(s)
+

Minimum quantity for "8 Way 1GHz Splitter 1 Port Power" is 1.

$19.99
Add to wish list

Needed to make your legacy system work with Dishpro LNBs & switches.DishPro adapters allow you to use a Legacy receiver with DishPro switches and LNBF's. The DISHPro Adapter is required for all DISH Network Receivers; 1000, 2000, 2700, 2800, 3000, 3700, 3800, 3900, 4000, 4700, 4900, 5000, 6000, 7100, 7200 and DVHS when used in conjunction with DISHPro LNBFs.Models 301, 501, 508 and 721 DO NOT require the DISHPro Adapter. Product Features: Direct Plug-N Class 2 Transformer INPUT : 85~135VAC 60Hz 0.45W OUTPUT : 20V DC 750mA (L.P.S) Excellent Condition

12 item(s)
+

Minimum quantity for "Dish Pro Adapter" is 1.

$50.00
Add to wish list

A DishPro 21 (DP21) Multi-Dish Switch allows you to receive signals from two DishPro LNBF's and send these signals to a DishPro satellite receiver.Use this switch to combine a Dish500 with a Dish300 or combine two Dish300's together. Both LNBF's and all receivers must be DishPro Series. You can't combine older Legacy LNBF's with DishPro LNBF's. This is a lower cost solution compared to adding the SW34 Switch. ONLY use the DP21 with DishPro LNBF's, like DishPro Twins and Quads, DishPro Receivers and non-DishPro receivers equipped with the DishPro Adaptor.

14 item(s)
+

Minimum quantity for "DP21 Dishnetwork Multi Switch" is 1.

$29.00
Add to wish list

Low cost, high quality splitters for dividing an RF 5-900Mhz signal. Great accessory when you have multiple TV connections.Passes DC and IR to all ports.This dependable splitter is designed to work in the 5-900MHz range and features a zinc diecast case with machined F-ports. The mounting tabs come with screws and grounding port. Product Features: Number of Outputs: 2 Frequency: 5-900MHz Insertion Loss@1GHz: 3.7dB Isolation: 23dB Low cost, high quality splitter for dividing an RF 5-900 MHz signal. Great accessory when you have multiple TV connections.

36 item(s)
+

Minimum quantity for "Skywalker 2 way splitter for off air and satellite signals" is 1.

$3.99
Add to wish list

This diplexer from Perfect Vision is a high performance device with outstanding specifications. It separates or combines off-air  TV- Antenna and Satellite signals from or onto a single feed coaxial line You will need one of these at each end of the cable. One to combine the signals on one side and the other split the signal at the other end . They are also used with a multi-switch (combines the signals) to split the  signals prior to connecting to the receiver. Features:  40-2250 MHz with 75OHM terminators insert off=air signals into four outputs of Phase III LNBFs  Use this diplexer to connect your off air antenna to a 1820DISH  Mixes or diplexes 950-2250 MHz and 40-2150 MHz bands  Low through loss and high isolation design  Use to receive local HDTV digital channels  Designed for outdoor use  Allows off-air and satellite signals to be fed on a single cable  DC power pass provided from the IRD to the LNB Diagram:

255 item(s)
+

Minimum quantity for "Perfect Vision PVDP3 High Grade Diplexer PVDP3" is 1.

$2.99
Add to wish list

KU-Band Dual Single LNBF, I/P Frequency:  11.7 ~ 12.75 GHz,  O/P Frequency:  950 ~ 2000 MHz Noise Figure: 0.3 dB L.O. Frequency: 10.75 GHZ. Fetures : L.O. Phase Noise (TYP):  -70 dBc/Hz@1 KHz -90 dBc/Hz@10 KHz -105 dBc/Hz@100 KHz  Gain: 65dB(TYP)  Output VSWR  2.0:1  Image Rejection  45dB(min.)

496 item(s)
+

Minimum quantity for "KU-Band Dual Single LNBF" is 1.

$29.99
Add to wish list

These high quality splitters work up to 2300mhz. Extremely durable long lasting design.If you need to split your satellite TV signal into 4 outputs, these splitters have a hard to beat price and great quality.Our great prices make this an unbeatable deal Check out our great selection of everything you need at our eBay store.a1components.com OR at our company website.Are you an installer, contractor, designer, home builder, or home enthusiast? Most of our products are available in large quantities. Just check our store! Features: These high-quality splitters feature an extremely durable, long lasting design.Diode Steered, Dual Ground Passes DC and IR from Outputs to Input (will not pass DC from input to output).When used on a satellite TV system these can be used after the receiver to split for multiple TVs. Impedance: 75 Ohms RFI: 120dB Insertion Loss (dBMax): 5-40MHz: 8.0 40-1000MHz: 8.3 1000-1750MHz: 9.5 1750-2050MHz: 10.8 2050-2300MHz: 12.6 Isolation (dB Min): Weight:0.3 lbs

10 item(s)
+

Minimum quantity for "Skywalker Signature Series Splitters 5 2300MHz 4 way" is 1.

$7.99
Add to wish list

This mini diplexer can be used for separating signals as a splitter or combining signals as a combiner. Allows off-air signals and satellite signals to be fed on a single cable. DC power pass is provided from the satellite port to the input in order to pass satellite receiver LNB voltage. This device allows you to combine your local TV signal with your satellite signal and use only one wire. (Normally 2 of these are required) Works with Dish Pro Plus. Features:  Insertion Loss In/Out-TV: 40-860MHz 1.5±1.0dB, 950-2300MHZ 15dB  Insertion Loss IN/OUT-SAT: 40-860MHz 20dB, 950-2300MHz 2±2dB  DC-Pass IN/OUT-TV: None  DC-Pass IN/OUT-SAT: 500mA. Max  Connectors: All "F" Type Diagram:

35 item(s)
+

Minimum quantity for "Skywalker Signature Series Mini Diplexer" is 1.

$0.99
Add to wish list

The 8-Way splitter is designed for use on the SWM. Features: Frequency Range: 2-2150Mhz 1 Input & 8 outputs Could be used indoor & outdoor DIRECTV Approved

21 item(s)
+

Minimum quantity for "Zinwell Split 8 Z 8 1 Input 8 outputs" is 1.

$19.99
Add to wish list